A kitchen countertop sample may be shorter than the finished product but have an irregular corner or cutout. For Brazil LCL, use the envelope and handling method of the final pack, not the bare sample length. A projecting base, wing or corner protector can change how it can be handled.
Measure the furthest points and state the normal handling orientation. Confirm fork access, stackability and any off-center weight. A “keep upright” mark is not a substitute for equipment that can maintain that position during loading and unloading.
Quote standard cartons and irregular cases separately. List dimensions, weight, ID and a representative picture for each. Do not replace very different packages with an average. Check whether minimum rating or special handling applies and which unit controls it.
An upright sample with a vulnerable cutout may need support verified by the packaging and warehouse teams. Confirm destination handling and vehicle fit too. Switching to FCL does not eliminate the need for a secure load arrangement.
Give the warehouse front, side and base views with readable dimensions. A rendering does not reveal base projections or fork access. Record the accepted arrival and handling method alongside the quote. If the buyer adds standard cartons, check how they will be secured rather than treating the whole load as one standard pallet.
When packaging changes, withdraw the old measurements and reprice before booking. A nominal cube saving is not useful if the sample arrives unusable for fitting or material selection.